VentDock Installation



Quick Installation Tips

  1. Position the VentDock™ rear housing on the wall and level it. *Option of adding sealant around the Vent Dock rear housing. Fasten to the wall using four #8, 5/8"–1-1/4" Phillips wafer or truss head screws through the slotted mounting holes, one per side; select screw length based on substrate.
  2. Position the wall vent over the VentDock rear housing. Fasten to the VentDock Rear housing with four #8, 5/8"–1- 1/4" Phillips wafer or truss head screws through the mounting holes; select length based on substrate.
  3. Install siding around the VentDock.
  4. Snap the trim ring into the VentDock rear housing. Apply even pressure until it is fully seated and flush with the siding surface.
PDF SpecsIntroduction and Specifications Sheet
DWV4T and DK40T Installed

Variable Profile

The VentDock trim ring will snap into place snugly across different siding depths.